还剩13页未读,继续阅读
本资源只提供10页预览,全部文档请下载后查看!喜欢就下载吧,查找使用更方便
文本内容:
XXXX
四、五层装饰工程施工临时用电方案编制单位:编制日期:2010-10-08现场临时用电施工方案工程名称工程地点施工单位编制单位编制人XXX技术负责人XXX编制日期2011年10月8日审核负责人XXX审核日期:1011年10月8日审批负责人:审批日期:年—月—日
三、现场临时用电应遵守三项基本原则
四、照明供电线路
五、主要电气、施工机械设备用电量现场临时用电施工方案为贯彻国家安全生产的方针和法规,保障施工现场用电安全,防止触电等事故的发生,根据规范及有关现场安全防护规定,结合ZJY会所装饰工程(二段标)的具体情况特点,制定本施工组织设计方案,
一、施工现场布置
1、概况XXX是一栋建筑水准高、技术要求严的高档综合商场我司负责地上4-5层的装饰施工,约9000平方米
2、线路分配由总包方指定电源每层引出3个回路,选用VV-4X16+1x6mm2橡皮护套铜芯多股软电缆引至我司提供的二级分箱,供每层设备使用所需电源
二、安全用电技术措施和电气防火措施
(一)专业人员管理施工现场临时用电由专人负责现场,维修或拆除临时用电箱必须由专业电工完成各类用电人员注意以下内容
1、掌握安全用电基本知识和所有设备性能;
2、使用设备前必须按规定穿戴和配带相应的劳动保护用品,并检查电气装置和保护设施是否完好,严禁设备带“病”运行;
3、停运的设备必须及时拉闸断电,锁好开关箱;
4、保护所有设备的负荷线、零线和开关箱,如发现问题及时解决;
5、搬迁或移动用电设备,必须切断电源后方可进行;
6、不许带电作业;
7、设备维修断电时,必须在相应开关箱、配电箱内控制开关上挂明显的维修停电标志牌
1、现场配电箱及开关箱采用本市产品,采用TN-S配线系统
2、配电箱及开关箱装设在干燥、通风及常温场所,不得装设在易受外力撞击、强烈震动和热源的地方,室外配电箱设有防雨棚
3、固定式配电箱及开关箱装设端正牢固,其下底与地面的垂直距离为
1.4M;移动式配电箱及升关箱装设在坚固的支架上,其下底与地面的垂直距离宜大于
0.6M小于
1.5Mo
4、配电箱及开关箱内的工作零线并通过接线端子板连接,并与保护零线接线端子板分设
5、配电箱及开关箱的连接线采用绝缘导线,接头不得松动,不得有外露带电部分
6、每台用电设备有各自专用的开关箱,必须实行“一机一闸”制,严禁用同一开关电器直接控制二台及二台以上用电设备
7、开关箱必须装设漏电保护器漏电保护器装设在配电箱电源隔离开关的负荷侧和开关箱电源隔离开关的负荷侧漏电保护器的选择符合国标GB6829-86《漏电电流动作保护器(剩余电流动作保护器)》的要求
8、所有配电箱门均门配锁,配电箱及开关箱需贴上标签,注明负责姓名及公司名称;每月由专业电工进行检查维修一次,检查维修时,必须将其前一级相应的电源开关分闸断电,并悬挂停电标志,严禁带电作业
9、所有配电箱及开关箱在使用过程中必须按照下述操作顺序A、送电操作顺序为总配电柜一二级配电箱一三级分配电箱一手提箱B、停电操作顺序为手提箱T三级分配电箱T二级配电箱T总配电柜(出现电气故障的紧急情况除外)
(三)配电线路
1、橡皮电缆均为架空敷设并沿墙壁或电杆设置,用绝缘子固定、严禁使用金属裸线作绑线橡皮电缆的最大弧垂距地不得小于
2.5m
2、电缆垂直敷设的位置充分利用楼内的竖井、垂直孔洞等,并靠近负荷中心,固定点每楼层不得少于一处电缆水平敷设宜沿墙或门口固定最大弧垂距地不小于
1.8Mo
3、室内配线必须采用绝缘导线采用瓷瓶、瓷(塑料)夹等敷设,距地面高度不得小于
2.5MO进户线边墙穿管保护,距地面不得小于
2.5M并采取防雨措施
1、现场使用的各类电动工具,均有由专人负责,定期检查和维修保养进场使用需总包方派专人检查合格,加贴标签后方可使用
2、电动建筑机械或手持电动工具的负荷线,必须按其容量选用无接头的多股铜芯橡皮护套软电缆,其性能均符合国标GB1169一74《通用橡套软电缆》的要求,其中绿/黄双色线只能用作接地线
3、每日工作前必须对外用电梯的行程开关、限位开关、紧急停止开关、驱动机构和制动器等进行空载检查,正常后方可使用检查时必须有防坠落的措施
4、焊接机械放置在防雨和通风良好的地方焊接现场不准堆放易燃易爆物品交流弧焊机变压器的一次侧电源线长度不大于5m进线处必须设置防护罩;二次侧焊把线长度不大于30M
(五)接地与防雷
1、施工现场的所有电气设备金属外壳必须用专用接地线连接施工现场的电力系统严禁用大地作地线或零线接地线由箱式变压器零线引出,不设开关或熔断器防雷接地的电气设备必须同时做重复接地以保证接地电阻值达到要求
2、与电气设备相连接的保护零线的截面积采用不小于
2.5mm2的绝缘多股铜芯线保护零线的统一标志为绿/黄双色线,在任何情况下不得使用绿/黄双色线做负荷线
3、现场埋地电缆与设备连接时严格按要求接线、相线分别为A相黄色、B相绿色、C相红色,零线为浅兰色,接地线为绿/黄双色线
4、箱式变压器重复接地电阻不得大于4,其他接地线每一重复接地装置的接地电阻值不大于10手持式用电设备的保护零钱采用绝缘良好的多股铜芯橡皮电缆其截面积不得小于
1.5mm2其芯线颜色为绿/黄双色线
(六)电气防火措施
1、电动工具使用完毕立即切断电源;
2、临时线路使用完毕及时拆除,不得留有断线头;
3、发现电气设备有燃烧现象,及时切断电源,并用灭火器扑灭;
4、发现触电、首先切断电源,然后再采取救护措施;
5、易燃易爆场所,危险品库均作为重点防火区域对电器线路和设备均按照重点区域的防护要求办理
三、现场临时用电应遵循三项基本原则
1、必须采用TN-S接地,接零保护系统;
2、必须采用三级配电系统;
3、必须采用两级漏电保护和两道防线I、照明供电线路
(一)照明灯具电源末端的电压偏移符合下列数值:
1、一般工作场所的电压偏移允许为额定电压值的-5%〜5%远距离电源的小面积工作场所,电压偏移允许为额定电压值的T0%〜5%
2、一般场所选用额定电压220v的照明器具
(二)在潮湿、导电灰尘严重、灯具距地面不低于
2.4M或易带电的场所使用安全电压,使用行灯电压不得超过36V
(三)照明线路分区域控制,随用随开,用后及时关闭,无人工作的区域工作灯不常开(除通道外)
五、主要电气、施工机械设备用电量XXXX2010年10月8日序号机械名称单位数量功率/每台合计功率(Kw)备注1木工锯床台
41.
24.82空压机台
24.593电焊机台45204瓷砖切割机台
100.
555.55冲击锤把
100.556手枪钻把
300.
5516.57砂轮切割机台6169修边机台
40.25110照明个
600.
063.611总计功率(Kw)
71.4。